Eaton Pullies

[Sixpipes]

http://www.f150online.com/galleries/images/211-300-8821.jpg

Martin Mfg. pullies for Eaton blower. There are three billet pullies in the set (2.78", 2.86", and 2.95") and they use the stainless press-on "acorn" pictured above. Nice bling factor. $150 :cool:

http://www.f150online.com/galleries/images/211-300-70174.jpg

[dboat]

Very nice bling..

since I am a bit of a bling kind of guy.. I would like to see a sticky of different underhood bling, another of passenger cabin bling, etc etc..

Dana

[Silver_2000]

Very nice bling..

since I am a bit of a bling kind of guy.. I would like to see a sticky of different underhood bling, another of passenger cabin bling, etc etc..

Dana

Create the thread in the Recommends section and Ill sticky it

[QDRHRSE]

How much Extra boost is each of those pulleys worth? Can they be installed without removing the blower?

[Sixpipes]

How much Extra boost is each of those pulleys worth? Can they be installed without removing the blower?

The smallest is equivalent to approximately a 2#er. Larger = less boost, but only by about 1/2# each. The stainless acorn you see in the picture presses on the stock Eaton shaft. The pulley is secured by a screw in the end of the shaft and the three pins on the acorn fit into the back of the pulley. I'll see if I can get you a picture or two. :cool:

Kind of like this...

http://www.svtgalleries.net/gallery/data/500/pulleys_rev.JPG