PDA

View Full Version : JLP like KB plenum on NLOC



wesman
04-16-2007, 01:52 PM
Made of sheetmetal...definitely different than the polished sheetmetal look, but should work the same

Only $355 shipped

http://www.nloc.net/vbforum/showthread.php?t=153428

--wes

slick-svt
04-16-2007, 02:00 PM
Recycled toolbox?

99WhiteBeast
04-16-2007, 03:55 PM
I saw that and thought it was cool- one off for sure

slick-svt
04-16-2007, 04:16 PM
Have some matching valve covers?

wesman
04-16-2007, 04:39 PM
Jimmy,

If you were in the market for one I'd bet you'd be happy about it. The plenums run $650ish from JL and used ones run at $500+ for the polished sheetmetal plenum.


Some of the stuff I've seen on peoples trucks/under folks hoods make this thing look like a masterpiece.

--wes

slick-svt
04-16-2007, 05:30 PM
Jimmy,

If you were in the market for one I'd bet you'd be happy about it. The plenums run $650ish from JL and used ones run at $500+ for the polished sheetmetal plenum.


Some of the stuff I've seen on peoples trucks/under folks hoods make this thing look like a masterpiece.

--wes
Hell ya I'd use it might have it podercoated

L8 APEX
04-16-2007, 05:56 PM
That is tough like truck nuts!:rolleyes:

FRDRCING
04-17-2007, 08:19 PM
That was very well made. Not sure If I like the look of a dimond plate for a plenum.

wesman
04-20-2007, 12:17 AM
Down to $300 shipped....not bad