JLP like KB plenum on NLOC

[wesman]

Made of sheetmetal...definitely different than the polished sheetmetal look, but should work the same

Only $355 shipped

http://www.nloc.net/vbforum/showthread.php?t=153428

--wes

[slick-svt]

Recycled toolbox?

[99WhiteBeast]

I saw that and thought it was cool- one off for sure

[slick-svt]

Have some matching valve covers?

[wesman]

Jimmy,

If you were in the market for one I'd bet you'd be happy about it. The plenums run $650ish from JL and used ones run at $500+ for the polished sheetmetal plenum.


Some of the stuff I've seen on peoples trucks/under folks hoods make this thing look like a masterpiece.

--wes

[slick-svt]

Jimmy,

If you were in the market for one I'd bet you'd be happy about it. The plenums run $650ish from JL and used ones run at $500+ for the polished sheetmetal plenum.


Some of the stuff I've seen on peoples trucks/under folks hoods make this thing look like a masterpiece.

--wes
Hell ya I'd use it might have it podercoated

[L8 APEX]

That is tough like truck nuts!:rolleyes:

[FRDRCING]

That was very well made. Not sure If I like the look of a dimond plate for a plenum.

[wesman]

Down to $300 shipped....not bad