watch Z06 go bang on dyno

[Silver_2000]

zcEhDA8jMAM

[tiffo60]

:eek2:

[TXLIGHTNING]

:eek: OUCH!!!

[bluesvt]

I hope that was on purpose otherwise that guy is an idiot.

[TXLIGHTNING]

I hope that was on purpose otherwise that guy is an idiot. No chit! What were they running that car to, 200mph :hammer:.

[ZeusSVT]

:hammer:

[GoldLS1]

Haha... thats almost a year old!! It was Lances car down at HPE in Houston. In the video you will hear the car rev up real fast when the second stage of nitrous comes on... That is the point where the dyno "went out" (It actually broke the load cell on the dyno). So during this time, all the nitrous was getting sprayed into the intake manifold, but not all of it was being used due to the speed in which the motor was accelerating.... then the dyno decided to load up. Now all that unused nitrous has to go somewhere. due to fuel puddling and everything that can happen in a state like this (fuel is obviously heavier than N20), the mixture going into some of the cylinders was not ideal, thus causing a few cylinders to run too lean. That's when you can see pieces of pistons and spark plugs start coming out of the exhaust. BTW it ended up making 590 n/a and 880 on 2 stages after it was put back together, mods: HPE 428 LS7, Greg Good Stage 2 heads, HPE Stage 3 cam, Speedtech Fogger, NOS plate kit, Mcleod Twin disk clutch, Borla exhaust.