Simple Quick Dyno Results

[slick-svt]

Here is the 94 no a/f just wanted a baseline....

http://www.svtgalleries.net/gallery/data/500/medium/dyno_day_2-8-08_008.jpg

And the 03 I had pushed the E-brake on the second run when I got in.:flaming:
I was running a little rich, my goal was 400hp and 500tq got close....:tu:


http://www.svtgalleries.net/gallery/data/500/medium/dyno_day_2-8-08.jpg
Not bad for a Predator Tuner and no custome tune, The staff at Simple Quick were very friendly and the were some bad ass cars up there...:tu:

[nacklas]

Nice!!! How much for three pulls..did you have to set up a time to go in?

[slick-svt]

I did 3 pulls on the 94 and two on the 03 for $100, but I had time to make adjustments (no including the E-brake :hammer:)
I did call them and make sure that they could fit me in
they're number is 817-738-7223
They said they would work a dyno day for everyone (prices cheaper) but its usually $75 and hour. I was there for a little more than an hour plus I had two trucks.

[slick-svt]

Here's a small video, couldn't get the other to upload, If you listen carefully you can here the massive air flow fron the K&N.....:rll:

http://www.svtgalleries.net/gallery/data/500/thumbs/dyno_day_2-8-08_005.avi (http://www.svtgalleries.net/gallery/showphoto.php/photo/23986)

[99WhiteBeast]

That is about what my stock 95 (CAI, shorties) pulled 210HP/240TQ when I had it.

Good numbers on the 03- what mods?

What and where is this place you dyno'd? I'm not familiar with it.

[tiffo60]

That is about what my stock 95 (CAI, shorties) pulled 210HP/240TQ when I had it.

Good numbers on the 03- what mods?

What and where is this place you dyno'd? I'm not familiar with it.

simple quick does alot of LS1 based stuff and some mustang stuff, they are off of 377 and 20 in benbrook

[slick-svt]

That is about what my stock 95 (CAI, shorties) pulled 210HP/240TQ when I had it.

Good numbers on the 03- what mods?

What and where is this place you dyno'd? I'm not familiar with it.

LFP throttle body and upper intake, 95mm CAI, 6lb pulley, predator tuner, unknown cat-back

[BC Lightning]

LFP throttle body and upper intake, 95mm CAI, 6lb pulley, predator tuner, unknown cat-back

My truck never ran good with that 95mm MAF, once I switched to a 90mm SCT BA 2400 ran real strong

[slick-svt]

My truck never ran good with that 95mm MAF, once I switched to a 90mm SCT BA 2400 ran real strong

I also did a boost by pass, don't know if that makes a crap or not.
They put the a/f behind my second cat, I had it too rich I bet it would have made a little over 400hp and I bet over 500tq. I'm going to take it back in a month or so.