Futher lowering my front end!!

[In2deep]

I have the complete hotchkis tvs on my lightning, the front however is not low enough, what do i do at this point with it, lower control arms, cut springs?? :confused:

[Mark #2]

I have the complete hotchkis tvs on my lightning, the front however is not low enough, what do i do at this point with it, lower control arms, cut springs?? :confused:

What do you have for upper isolators?

[In2deep]

Talking about the bump stop??

[Mark #2]

Talking about the bump stop??
No the thing on top of the spring.

[In2deep]

I watched the guys install the springs i dont recall anything on top, sure there be?

[Mark #2]

I watched the guys install the springs i dont recall anything on top, sure there be?

Yes, there must be, there is ~3/4" there from stock isolators.

[In2deep]

Sweet so even though the springs where changed out these isolators are still there, 3/4 is what i need..

[Mark #2]

Sweet so even though the springs where changed out these isolators are still there, 3/4 is what i need..

Some springs came with thin isolators, some did not. You will have to jack it up and pull a wheel to see.

[In2deep]

As i recall i did not have any isolators on the springs, i have a tonneau cover and its making the truck look more lower in the rear than the front

[L8 APEX]

I am sure the rubber is on top of the spring. You will max out the alignment though. So it will wear tires a little faster.