Help!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

[svtroky]

Hey Señor Terry I have this parts in my truck C&L plenum, LFPsingle blade TB, SCT 2400 MAF brand new w/ 4" air cleaner adaptor,
SCT tuner brand new, C&L elbow, Air raid cold air intake and I have a 6lb lower pulley (one piece) but not on the truck I wanted to ask u or
anyone can I use the 6lb lower pulley with a 2.8 upper that its on my truck and get it tune or is there no way and do I need to go to a Stock Upper.

1 more thing if I can use the 6lp can I get it tune by u Terry or some one before wee go to Ennis or there's no way.:burnout:

[tiffo60]

call Terry and ask


214.923.0045

[nacklas]

That's going to be a tough one. He mostly does his work on the weekends!

[L8 APEX]

A 6 isplenty by itself. I can install and tune it around 3pm today. That is all I can try to do.

[L8 APEX]

I am busy at work right now. Do you have good plugs, fuel filter etc? The SCT MAF will require wideband and data logging to tune 150-200. I can tune it to the stock 90mm without any issues $100. $60 to install lower pulley.
I do most of my work at one of the club members houses in Lewisville. I have a dental appt at noon and should be available after 2pm.

[L8 APEX]

a 2# plus a 6 lb make for lots of heat. You would be risking detonation without a chiller, super cooler etc. That much boost would need a MAF and custom logging tune.

[svtroky]

a 2# plus a 6 lb make for lots of heat. You would be risking detonation without a chiller, super cooler etc. That much boost would need a MAF and custom logging tune.

:confused: so do i need to take off the 2.8 that is all ready in the truck if so do u have a stock upper.

its got a new fuel filter 2 months old, and the plugs are NJK's 2 months old
2, will do an oil change on friday

And for the SCT 2400 MAF ill put the 90mm on there for now .

Can u send me and address were to meet u at.

[TXLIGHTNING]

On such short notice I would call him bro. 214.923.0045