crankcase filters

[dboat]

my brother picked up a jlp crankcase filter (looks like a small k&n) but now is wondering where does it go? I dont have one and really dont have an idea, so where does one install one of these things in their Gen 2?:confused:

Dana

[zforce77]

Found this on a Ford forum.
OK, if you mod the inlet tube with the crankcase filter as pictured in the other post, your allowing un-metered air to enter the engine causing a lean condition (extra air and no extra fuel makes lean). The PCV feeds into the back of the top part of the blower and the hole that you plug used to get its air AFTER the MAF so the air is metered, cycled through the engine crankcase and then into the blower creating proper a/f ratio. With that hole plugged and the filter open to the outside air, it enters the engine UN-METERED, goes through the crankcase and into the engine BEHIND the MAF, ie un-metered.

[dboat]

wow, thank you very much.

Dana

[In2deep]

I had mine where the oil cap was, it screws on there and helps cool the engine oil??? looked cool..

[L8 APEX]

What a jack wagon...