uh oh, wobley pulley

[microsuck]

Terry,
i cut that 99 4# pulley to fit my 01. it is a pretty good fit ( but not perfect) the 3 bolts do line up correctly thought. when I use it, it wobbles a bit. I think it will wear on the crank or something. whats your verdict? fine or dangerous?
Andrew

[L8 APEX]

Does it wobble in and out or up and down:D Some pulleys have a touch of runout like thousandths. The key is that the load is centered on the hub and bolts just hold it in place.

[microsuck]

I guess I will have to go look more closely.:twitch: It bolts fine, but I dont remember the stock one shaking. The load is on the hub, cause it was hard to get on there, and since the bolts line up I would assume it is even.
Andrew

[cpeapea]

it didnt look like it was shaking that much, i think it was going up and down, i was also looking at the tensioner to see if it was affected and it didnt seem to wobble more than with the stock pulley