New look

[andy_cain]

Finally got a chance to get some pics of the new powder coated billet grills after I got them installed....
BTW ... Directions made NO mention of needing special tools Dremmel, pop rivet gun, etc.)
It was worth the hassle !!!:banana:

[Sixpipes]

Great looking job Wayne. :tu:

[RedNemesis01]

can't wait to see it with your ram air hood...btw...just so I know...what was the rivet gun needed for?

[L8 APEX]

The new grill is held in by drilling holes and popping rivets through the shell to retain it;)

[RedNemesis01]

is the factory grill held in by screws? Or do you have to drill out rivets, like w/stang bumper covers?

[Sixpipes]

The factory grille is installed using plastic clips which usually are broken off when removing. :cool:

[andy_cain]

Ya, what they said....Powder Coated from the factory...rules:D
I can't wait to see this with the Cervinis hood either.
Should be installing my Throttle body and Bassani tomorrow night.
May attempt the keyless mod...think I will read the directions for that first:twitch:

[RedNemesis01]

does that keyless mod send a signal to the keyless remote receiver? i.e. once installed, will it have the same effect as hitting the unlock button on the remote? if not, has anyone done this with an aftermarket alarm system?

[andy_cain]

I think that is how it works, directions for the install are out at the svtlightnings.com under the "how Too" section....guess I better print them out and start reading them now...LOL:D

[L8 APEX]

The keypad communicates with the factory RAP module and is the same as hitting the unlock button. It depends on how they are hitting the aftermarket input signal though. You have a wack alarm:D

[RedNemesis01]

well...as long as all the other Duncanville hood rats think that about it, I'm happy with it :banana: :banana: