How much would install of 373's be ?

[wesman]

Terry,

I have a set of 373 gears I got from a NLOC member for charity. How much for install on a set of those? I only have the gears....also will I need the shim kit that I have seen around to use them ?


Need all the help i can get...need to get out of my high 13's and low 14's :hammer:

--wes

[L8 APEX]

I'll check tomorrow with the guy that sets up my rear ends. Rough guess is 300 parts and all. Those rear ends are tough and require $ynthetic goop.

I checked and my first guess was correct 300 done and driving:tu:

[Mark #2]

Terry,
Are you saying drive in, drive out, for $300 for 3.73 gears?

[wesman]

Originally posted by L8 APEX
I'll check tomorrow with the guy that sets up my rear ends. Rough guess is 300 parts and all. Those rear ends are tough and require $ynthetic goop.

I checked and my first guess was correct 300 done and driving:tu:


Just noticed this thread again....so it's $300 for the parts and labor ? That's a pretty kick ass deal.

How much for just install? I bought a new set for the charity deal going on back in WFC5 in June.


--wes

[Logan]

It books as a 8 hour job.

My 4.10's into the 8.8 in my Marauder cost me $366 labor, $200 for the gears, another $100 worth of misc gaskets, seals, fluids, etc etc...

If you have a nice shop that works at $40-45 an hour, you already have the ring & pinion, so count on you walking out with a bill for $500.

[wesman]

After reading Logan's comment as well as Terry's original it seems the aformentioned parts are those required to install the gears. Still not too bad of a deal I suppose....gonna have to wait though...so many other things going on.

--wes

[L8 APEX]

300 is labor and installation supplies. Gears are extra.

[Mark #2]

Next mod, need to accumulate some $$$$$

[Logan]

At 300, yur gettin' a deal, so go for it!