PDA

View Full Version : Need Help with Plug Gapage



FRDRCING
09-12-2004, 06:52 PM
Need to know what to gap the TR6'S at with the following mods.
PSP 4# Lower
95 Maf
C&L Inlet
AccufabTB
JLP Ram Air
Pace Setter Shorties
JDM SilverBullet
Oil Breather Cap
PSP Flip Chip
FTVB
2400 Stall
4:10'S

Blower is going to Mark tommorow and need to know what to gap the plugs at, Dad said stock That can't be right can it :confused: I will need help changeing them if anybody wants to help me who has all the tools.

Sixpipes
09-12-2004, 07:36 PM
I'm not sure gappage is a word. but my TR-6s are gapped at .038 with similar mods. :cool:

Avalanche
09-12-2004, 07:41 PM
I would agree I gap mine at .036/.038 with simalar mods as well.

TX SVT LIGHTNING
09-12-2004, 08:12 PM
.038" is what I had as well with similar mods on the old '01. (same plugs)
Anyone have a set Jacobs Electronics Gapping Pliers :)

03LightningRocks
09-13-2004, 09:19 AM
Mine are gapped at .035........but I run as much as 20lbs of boost on them, so anymore gap than that and I would get flame blow out.

I vote to go with the .038 Dennis speaks of. You want to run as large a gap as your set up will permit...........

I ran as high as .040 with the comparable Denso's and 17lbs of boost, but got occassional blow out, so I tightened them up to .038.


Rocks:cool:

Tex Arcana
09-13-2004, 12:41 PM
Has anyone tried the Brisk plugs yet? :D