665hp stocker!!!!!

[03'svtlight]

http://www.procharger.com/2005_mustang_600hp1.shtml I guess that 3 valve is the one. Anyway you slice it, that is one bad mustang. Lets see, chip, longtubes, and a blower = 350+hp and it all stays together and blows cold a/c. I think I want one.:cool:

[Shiner1]

http://www.procharger.com/2005_mustang_600hp1.shtml I guess that 3 valve is the one. Anyway you slice it, that is one bad mustang. Lets see, chip, longtubes, and a blower = 350+hp and it all stays together and blows cold a/c. I think I want one.:cool:

No way!!! Really:confused:

[03'svtlight]

No way!!! Really:confused:
what??:confused:

[gagspa]

I wonder how much boost they are running and how long until it blows the engine.

[03'svtlight]

I wonder how much boost they are running and how long until it blows the engine.
It says 16psi with 100 octane and there race intercooler. With that intercooler that kit I believe is up close to $7 grand. Not cheap but very impressive. The other car on their site is claiming 14psi on 93. Could stay together since they send the correct tune with the blower.:cool:

[Shiner1]

[quote=03'svtlight]what??:confused:[/quot

Can you really pull 600+ hp out of a stock bottom end? hard to believe.

[gagspa]

It is definitely possible. I know a couple guys doing it with stock SOHC Mustangs, but they don't usually last long. A lot of it depends

I would be concerned about the tune that they send. I have seen several of these "off the shelf" tunes that run extremely lean. I would want to put the car on a dyno and check the air/fuel before driving it hard.

[QDRHRSE]

That kind of power with a stock bottom end is like a grenade with the pin hanging out. If anybody knows how to blow up a perfectly good Mustang it's me!

[PoorSvtman]

http://www.procharger.com/multimedia.shtml

the 4.6 gt drag test vid is at KCIR where L fest was... Looks a little better in the vid than when we were there.

[FRDRCING]

That is bad ass